Effect of bias voltage on the structure and properties of CoCrFeNi high entropy alloy thin films prepared by magnetron sputtering

Abstract

In this study, CoCrFeNi high entropy alloy thin films were prepared on 304 stainless steel and single crystal Si substrates using the direct-current magnetron sputtering process under different bias voltages. The effects of these bias voltages on the film micrographs, phase structure, surface roughness, corrosion resistance, and mechanical characteristics of thin films were studied by a scanning electron microscope, transmission electron microscope, X-ray diffractometer, atomic force microscope, electrochemical workstation and nanoindentation tester, respectively. The results indicated that all films exhibited equiaxed nano-scale grains and developed a columnar structure. Fe, Co, Cr, and Ni were uniformly dispersed in all films and all films displayed face centered cubic solid solution (FCC). At a bias voltage of 0 V, the CoCrFeNi HEAs film formed a FCC single phase. With increasing bias voltage, the crystallinity decreased and then increased, reaching the worst crystalline state at bias voltage of −200 V due to the fact that the structure of the film was composed of FCC nanocrystalline and amorphous biphasic structure. Meanwhile, the surfaces of the film prepared at bias voltage of −200 V exhibited the densest structures and the least roughness, with grain sizes reaching a minimum value of approximately 10 nm. In addition, columnar grains of the film prepared at a bias voltage of −200 V displayed the densest state and had the least size, thus this film displayed the best corrosion resistance of a minimum value 1.51 × 10−7 A/cm2, a maximum hardness of approximately 11.18 ± 0.2 GPa and a maximum elastic modulus of approximately 193 ± 2.8 GPa. The passivation films of CoCrFeNi HEAs films were mainly composed of Cr2O3.