Abstract
The effect of small amounts (0.2–2.0 wt.%) of bismuth oxide on the sintering behavior and microstructural development of Ce 0.9Gd 0.1O 1.95 (GDC) submicronized powders has been studied using XRD for the lattice parameter measurements, the constant heating rate (CHR) method in air to monitor the shrinkage kinetics of powder compacts, and scanning electron microscopy (SEM) to study the microstructure of the sintered samples. Sintering of GDC compacts was significantly improved by adding small amounts of Bi 2O 3 (≤2.0 wt.%), and samples of doped-GDC sintered at 1200–1400 °C for 2–4 h were dense bodies (98–99.5% of theoretical density). Measurements showed that the addition of Bi 2O 3 could reduce the sintering temperature by about 250–300 °C lower than that for undoped-GDC samples. A liquid phase-assisting mechanism was assumed as the main cause for the enhancement of the densification process. The average grain size of doped-GDC sintered samples grew with the increasing of Bi 2O 3 addition up to 1.0 wt.%, and then decreased indicating a poor wetting properties of the formed liquid phase.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
