Abstract
Ti(C,N) cermets were prepared by SPS method. The effects of nickel salt coating as well as ball milling times on the microstructure and mechanical properties of the cermets were investigated. SEM images shows that the nickel was coated homogeneously on the surface of Ti(C,N) powders by mixing Ni salt and Ti(C,N) powder. The grains of Ti(C,N)-based cermets became finer with increasing ball milling time. The flexural strength increased when the balling milling was below 48h, and then decreased with increasing of ball milling time, which was due to the decrease of the flake structure in cermets.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
