Abstract
The utilisation of fired clay-brick waste is of interest in the manufacture of building products due to both socio-economic and technological reasons. Autoclaving is an established process for manufacturing calcium silicate-based building products that affords rapid strength development. Clay-brick waste represents a source of alternative silica, which is more reactive than conventionally used silica and also contains alumina. This paper presents data on the effect of lowering the autoclaving temperature from commonly practised 180 to 170°C on OPC-quartz blends containing clay-brick fines as direct replacement of quartz at 4.3, 8.6 and 12.9 mass percentages. The hydration products of autoclaved OPC-quartz blends with clay-brick fines were characterised using simultaneous DTA-TG in combination with other methods.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.