Effect of aspect ratio, surface modification and compatibilizer on the mechanical and thermal properties of ldpe-mwcnt nanocomposites

Abstract

AbstractIn this work, nanocomposites of low density polyethylene (LDPE) / multiwall carbon nanotubes (MWCNTs) were prepared using melt blending. The effects of CNT aspect ratio, CNT loading, CNT chemical modification and the presence of a compatibilizer (maleated polyethylene) on morphology, mechanical and thermal properties of the CNT/LDPE composites were studied. Different MWCNTs were used: long CNT (LCNT); COOH modified CNT (MCNT) and short CNT (SCNT). FE-SEM images of produced nanocomposites show agglomeration of the MWCNTs. Addition of compatibilizer to both LCNT and MCNT nanocomposites improved their dispersion in the LDPE matrix. Yield strength and modulus increased with loading of various MWCNTs. However, ultimate strength, percent elongation and toughness reduced significantly for CNT loadings of 2% CNT and higher. The addition of maleated PE resulted in improvements of Young’s modulus, yield strength and ultimate strength but no impact on elongation at break or toughness. Addition of compatibilizer did not affect the crystallinity of the produced nanocomposites. In general, the use of CNT with high aspect ratio and the addition of compatibilizer and chemical modification improved the dispersion of MWCNTs and consequently improved most of the mechanical properties except elongation at break and toughness.