Abstract

This study investigated the effect of heat treatment (100°C and 150°C) with or without addition of tocopherol (0 mg/L - 300 mg/L) in the formation of free fatty acids in differently processed coconut oil, dry processed virgin coconut oil (DYCO), wet processed virgin coconut oil (WYCO), white coconut oil (WCO), paring coconut oil (PCO) and soya oil. FFA content of all oils stored for a period of 3 months were determined. The results show that WVCO had the lowest FFA content (0.035 %) followed by DYCO, WCO, Soya and paring oil. The initial FFA content reduced when the respective oils were heated to 100°C or 150°C. This indicates that heat treatment can improve the quality of coconut oil. Addition of tocopherol to DYCO, WYCO and WCO in 100 mg/L, 200 mg/L and 300 mg/L had a significant effect on controlling FFA development of the oil. Addition of tocopherol in 200 mg/L had significantly lower FFA content in DVCO both with and without heat treatment. WVCO and WCO had lowering effect of FFA due to addition of tocopherol in 200 mg/L. However it was not significant.

Highlights

  • Sri Lankan per capita consumption ofcoconut oil is about 4 liters (Central Bank report, 2002)

  • Initial Free fatty acids (FFA) content of paring coconut oil (PCO) is more than 10 times higher than the FFA of white coconut oil (WCO)

  • Virgin coconut oil produced through wet and dry process showed lower FFA content compared to white coconut oil which is produced using copra

Read more

Summary

Introduction

Sri Lankan per capita consumption ofcoconut oil is about 4 liters (Central Bank report, 2002). Several methods are available for extracting oil from the kernel. Coconut oil is extracted from dried coconut kernels known as copra. Coconut oil is extracted from the fresh kernel using coconut milk in domestic level. Among the various types of coconut oil available, virgin coconut oil is a product which is extracted from kernel by using mild heat during oil extraction preventing chemical changes in the coconut kernels and ensuring physical separation of the oil from the kernel. More convenient method is the use of dehydrators to dry kernel at controlled temperature within 3-4 hours taking measures not to undergo chemical or microbial changes

Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call