Effect of annealing temperature on the synthesis and photocatalytic properties of Bi0.65K0.2Ba0.15FeO3 perovskite-like nanoparticle synthesized by sol-gel method

Abstract

BackgroundBiFeO3 shows promising applications in photocatalytic degradation, purification process, and in clean energy generation. The various fascinating properties of bismuth ferrite nanoparticles can be improved by doping the material at either of the A or B sites to give it extra photocatalytic advantage toward decreasing the energy bandgap and other photophysical properties of the material.ResultsIn this research, pure Bi0.65K0.2Ba0.15FeO3 perovskite material was synthesized using the sol-gel method via citric acid route in the presence of sodium dodecyl sulfate (SDS). The powdered nanoparticles were annealed at different annealing temperatures of 600, 700, and 800 °C each for 4 h in a muffle furnace and coded K2BFO 600, K2BFO 700, and K2BFO 800 corresponding to the annealing temperature of each portion. The powder nanoparticles were characterized using powdered X-ray diffraction (PXRD) to determine the crystallite structure. The samples displayed similar peak patterns with increase in intensity as the annealing temperature is increased indicating an increase in crystallinity. The impurity peaks in K2BFO 800, however, show that the sample may contain a secondary phase. Scanning electron microscopy (SEM) was used to determine the morphology, and UV-Vis spectroscopy indicated that all the powders were photoactive within the visible region of the electromagnetic spectrum. ATR-FTIR spectra of the samples were collected to study the formation and phase purity of the B-site in the perovskite structures. The photocatalytic performance of the powder was tested on methylene blue dye under visible light irradiation for the degradation studies. All powders showed photocatalytic ability after 2 h of irradiation with the powder annealed at 800 °C being better. The photocatalytic activities of the powders showed improvement on addition of 2 drops of 1 M H2O2 (80% degradation for K2BFO 800). The bandgap energy of K2BFO 800, 700, and 600 was estimated at approximately 2.00, 2.12, and 2.18 eV, respectively, using Tauc’s equation. The improved activity is as a result of photoabsorption of visible light by the doped powders causing generation of electrons and holes. The kinetic studies were carried out and the mechanisms of the photocatalytic reaction proposed.ConclusionThe effect of annealing temperature on synthesis of the material shows enhanced photoactivity in the presence of hydrogen peroxide leading to improved performance for the degradation of MB, and the catalyst can be said to be a good candidate for the treatment of waste materials.