Abstract
The effects of the annealing temperature on the microstructure and the corrosion behavior of duplex stainless steel 2507 were investigated by means of magnetic force microscopy (MFM), scanning Kelvin probe force microscopy (SKPFM), atomic force microscopy (AFM) and scanning electron microscopy (SEM). The SEM results indicated that the volume fraction of the austenite phase decreased with the increased annealing temperature. SKPFM/MFM measurements conducted in air at the room temperature and an ambient relative humidity of about 25% showed a higher Volta potential of the paramagnetic austenite than that of the ferromagnetic ferrite. The in situ AFM observation in a hydrochloric acid solution provided solid evidence that corrosion preferentially occurred in the ferrite phase. The sample annealed at 1100 °C exhibited a greater Volta potential difference between the ferrite and austenite and a higher corrosion rate in the ferrite, while that annealed at 1150 °C had a smaller Volta potential difference and a lower corrosion rate. The relative nobility and microstructure change of two phases, as well as their corrosion behavior, can be explained by the effect of the composition of alloying elements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
