Abstract
Ti6Al4V alloy thin wall was successfully fabricated by multi-laser beam wire-feed additive manufacturing in vacuum environment. The effect of annealing heat treatment (AHT) on microstructure and corrosion behavior of specimens in 3.5 wt% NaCl and 1 mol/L H 2 SO 4 electrolytes was investigated. Results showed that AHT led to the reduction of the non-equilibrium phase α′ and texture weakening. AHT700 was beneficial to achieve crystal refinement while AHT850 had obvious coarsening phenomenon. In addition, AHT could improve the corrosion behavior of the specimens due to the reduction of α′ phase and relief of residual stress. Compared with the specimen of AHT850, the specimen of AHT700 with finer crystal size and obvious texture weakening improved the corrosion resistance more obviously. • Ti6Al4V thin wall is fabricated via multi-laser beam wire-feed additive manufacturing (MLWAM) in vacuum environment. • The effect of annealing heat treatment (AHT) on microstructure and corrosion behavior in 3.5 wt% NaCl and 1 mol/L H2SO4 electrolytes is investigated. • AHT leads to the reduction of α′ phase, texture weakening and relief of residual stress. • AHT is beneficial to improve the corrosion behavior of MLWAM specimens.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
