Effect of Anionic Polyacrylamide Polymer on Frost Heave Mitigation and Its Implication for Frost-Susceptible Soil.

Abstract

Seasonally frozen ground regions occupy approximately 55% of the exposed land surface in the Northern Hemisphere, and frost heave is the common global problem in seasonally frozen soil areas. Frost heave induces uneven deformation of ground and damages railways, road paving, and buildings. How to mitigate frost heave is the most important technical issue in this field that has provoked great interest. Here, using freezing experiments, we investigate the effect of anionic polyacrylamide (APAM) polymer on frost susceptible soil. The results demonstrate a so-far undocumented inhibition of frost heave by APAM in freezing soil, namely APAM (tested at concentrations from 0.0 wt% to 0.60 wt%) slows down the frost heave by a factor of up to 2.1 (since 0.60 wt% APAM can decrease frost heave from 8.56 mm to 4.14 mm in comparison to the control experiment). Moreover, it can be observed that the maximum water content near the frozen fringe decreased from 53.4% to 31.4% as the APAM content increased from 0.0 wt% to 0.60 wt%, implying a mitigated ice lens growth. Hydrogen bonding between APAM and soil particles triggers an adsorption mechanism that accumulates soil particles, and thus can potentially inhibit the separation and growth of the ice lens. Moreover, the residue of APAM due to hydrogen bonding-induced adsorption in the pores of granular media may narrow seepage channels (capillary barriers) and provide an unfavourable condition for water migration. The use of APAM can also increase the viscosity of the solution, which causes a greater water migration resistance. This research provides new insights into APAM-influenced frost heave (introducing APAM into the soil can induce bridging adsorption between APAM polymer segments and a particle surface), can enable engineers and researchers to utilise chemical improvement design and to consider suitable actions (e.g., by injecting APAM solution into a frost susceptible soil or using APAM-modified soil to replace the frost susceptible soil) to prevent frost heave from having a negative impact on traffic roads and buildings in cold regions.