Abstract

One of the recommended post-stroke gait rehabilitation treatments is the use of an ankle–foot orthosis. In clinical practice, it is important to adjust the torque of the ankle–foot orthosis assistance to suit each patient’s body function and gait ability. The present study aimed to investigate the effect of changing the plantar flexion resistance of the ankle–foot orthosis on the post-stroke gait kinematics and kinetics during the early stance phase using a musculoskeletal model and an ankle–foot orthosis model. The subject was a male with post-stroke left hemiplegia who could walk independently without an ankle–foot orthosis and/or cane. The subject walked at a self-selected speed under the no ankle–foot orthosis condition and three ankle–foot orthosis conditions, each with a different plantar flexion resistive torque. A motion analysis system was used to measure the following spatiotemporal parameters: gait speed, step length, cadence, and step length ratio. In addition, the ankle angle of the paretic side, ankle torque of the paretic side, and plantar flexion resistance torque of the ankle–foot orthosis were calculated using a musculoskeletal model and an ankle–foot orthosis model. The results showed that the gait speed and step length ratio of all ankle–foot orthosis conditions were improved compared with the no ankle–foot orthosis condition. In particular, the condition with the smallest torque was the most symmetric of the four walking conditions. The condition with the smallest torque also resulted in the greatest increase in the dorsiflexion angle of the paretic side at heel contact. The internal dorsiflexion torque was most increased in the ankle–foot orthosis condition with the smallest torque for this subject. The simulation of the post-stroke gait in the present study contributes to the development of more effective gait rehabilitation treatment methods using an ankle–foot orthosis.

Highlights

  • The main causes of reduced gait function are disease and aging

  • The purpose of the present study investigated the effect of the magnitude of the plantar flexion resistance (PFR) of an ankle–foot orthosis (AFO) on poststroke gait kinematics and kinetics during the early stance phase using a musculoskeletal model and an AFO model

  • The left side step length tended to increase in the PFR1 and PFR 2 conditions compared with the no AFO condition

Read more

Summary

Introduction

The main causes of reduced gait function are disease and aging. Stroke is a typical disease that causes gait disability due to hemiplegia and sensory disorder. Stroke patients generally have decreased gait speed and step length, with an asymmetrical and abnormal gait pattern [1, 2]. Post-stroke walking is made difficult by abnormal gait patterns such as drop foot and instability. An ankle–foot orthosis (AFO) is one of the methods recommended for the treatment of post-stroke gait abnormalities. Several studies have reported that using an AFO on the paretic side improves gait speed, balance, energy cost, and gait kinematics [3,4,5]. The AFO has several functions, the plantar flexion resistance (PFR) function is effective in improving the post-stroke

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call