Abstract
The strengthening of steel structures can be effectively performed using carbon fiber-reinforced polymers (CFRP) plates. Specifically, the behavior of corroded and fatigue damaged steel bridges can be significantly improved using externally bonded (EB) or unbonded composite reinforcements. For bonded composites, the bond between the reinforcement and the steel substrate is the weak link of the system. Indeed, cohesive failure within the adhesive layer represents the main failure mode, which makes the selection of a proper adhesive fundamental to achieve an improvement of the system load carrying capacity and fatigue resistance. Within this context, the use of toughened adhesives represents a promising solution. However, research regarding these adhesives is still limited. In this paper, 18 single-lap direct shear tests are performed to evaluate the cohesive behavior of toughened and traditional adhesives. For some specimens, the full-range bond behavior, including the load response snap-back, was experimentally captured. The digital image correlation technique is adopted to evaluate the adhesives cohesive material law (CML). The effect of adhesive ductility, plate stiffness, and bonded length on the joint load response is investigated. Finally, experimental results are validated and discussed against the analytical predictions of a cohesive model based on a trapezoidal CML.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.