Effect of Addition of Previously-Synthesized Ce-TZP/Al2O3 Submicrometric Powder on the Properties of Al2O3-Based Ceramics

Abstract

This work investigated the effect of a composite of tetragonal zirconia with alumina-reinforced Ceria (ATZ) previously synthesized, on the properties of alumina-based ceramics (Al2O3). Monolithic alumina powder and Al2O3 powder mixtures containing 5, 10, 15 and 20 wt.% of Ce-TZP/Al2O3 were processed by high energy milling, compacted and then sintered at 1600 °C - 2 h. Sintered pure alumina and composites were characterized by relative density, scanning electron microscopy, X-ray diffraction and surface roughness. Then, the elastic modulus, the Vickers hardness, the fracture toughness and the 4-point flexural strength were evaluated. The results indicated an increase in relative density as a function of the addition of ATZ, with values ​​between 94.3 ± 0.8% and 98.9 ± 0.7%. The observed microstructure after sintering showed tetragonal ZrO2 grains with average sizes of 0.6 μm well dispersed in the Al2O3 matrix, which presents average grain sizes of around 1.5 μm. The crystalline phases identified in the composites were ZrO2-tetragonal and Al2O3 hexagonal. The addition of the composite (ATZ) in the alumina matrix generates a gradual reduction in the elastic modulus (398 ± 15 GPa ~366 ± 34 GPa) and in the hardness (20.5 ± 1 GPa ~17.3 ± 0.7 GPa) of the sintered ceramics. On the other hand, the addition of this same composite (ATZ) in the alumina matrix considerably increases the materials fracture toughness, reaching values of approximately 6.7 ± 0.9 MPa.m1/2. The same trend was observed in the flexural strength results which ranged from 258 MPa (5wt.% Ce-TZP/Al2O3) to 316 MPa (20wt.% Ce,Y-TZP/Al2O3). The Ce-TZP reinforcement acts as a toughening agent of the Al2O3 matrix due to the coupled mechanisms of toughening by zirconia phase transformation, residual stresses due to the difference in thermal expansion of the crystalline phases and differences in microstructural morphologies.