Abstract
The effect of a thermal treatment, i.e. annealing, on the adhesion of a thermoplastic polyurethane overmolded on a precoated steel substrate was evaluated. The hybrid part was subjected to three different annealing temperatures after the overmolding process. Adhesion of the thermoplastic elastomer was achieved by using an in-house-developed, two-step curable organic powder coating, which was selectively crosslinked to a polyallophanate state. The powder material was applied to the steel substrate by electrostatic charging followed by molecular crosslinking in an oven. The influence of the metal surface pretreatment was also evaluated regarding adhesion. The effects of the postthermal treatment were assessed through mechanical peel test, differential scanning calorimetry, atomic force microscopy, and scanning electron microscopy. Interesting results were obtained regarding strong adhesion between the precoated metal sheets and thermoplastic polyurethane after injection molding, especially in hybrids that were annealed at higher temperatures with the in-house adhesive coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.