Abstract
Statement of problem. With the development of new adhesive resin cements, the question of surface treatment of noble metal castings with primers has become an important issue. Purpose. This study compared the tensile bond strength and its durability of a new metal primer (Alloy Primer, Kuraray) to 2 noble metal alloys (Au-Ag-Cu-Pt and Au-Pt-Pd-Ag-In). Material and methods. Sixty cast disk specimens of each alloy were polished, grit blasted with 50 μm Al2O3, and ultrasonically cleaned in 96% isopropanol. Then, they were either nonprimed or primed only with the Alloy Primer or Alloy Primer combined with ED Primer (Kuraray). Plexiglas tubes filled with self-curing composite resin (Clearfil FII, Kuraray) were bonded to the metal samples with the use of an alignment apparatus and a self-curing luting cement (Panavia 21 Ex). The samples were stored in water, either for 3 days with no thermal cycling or for 150 days with 37,500 thermal cycles. After the different storage conditions, the tensile bond strengths of the specimens were determined. Results. The mean bond strengths increased over storage time for all groups, except for the grit-blasted Au-Pt-Pd-Ag-In group. However, only in the grit-blasted and the primed groups for the Au-Ag-Cu-Pt alloy was this increase significantly different (P<.01). After 150 days of storage, the mean bond strength to Au-Ag-Cu-Pt alloy was 38.8 MPa without priming, whereas it was 40.6 to 40.8 MPa with the use of the primers. After the same time, the mean bond strength to the Au-Pt-Pd-Ag-In alloy was 20.6 MPa without priming, whereas it was 31.9 to 37.8 MPa with the use of the primers. When comparing the different bonding methods and different storage times for the alloys, the superiority of the usage of both primers in combination was determined. Conclusion. The tested Alloy Primer significantly improved the bond strength of the dental adhesive resin cement (Panavia 21 Ex) to noble alloys. However, this effect depended on the alloy composition and was much greater for the Au-Pt-Pd-Ag-In alloy than for the Au-Ag-Cu-Pt alloy. (J Prosthet Dent 2000;84:554-60.)
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
