Abstract

In order to gain insight into how the addition of Cu element affects the crystallization mechanism of amorphous nanocrystalline alloys and soft magnetic properties, the crystallization behavior of (Fe0.83B0.11Si0.02P0.03C0.01)100-xCux (x = 0 and 0.5) amorphous ribbons was investigated based on kinetic and thermodynamic behavior under non-isothermal and isothermal annealing conditions. The results show that under non-isothermal annealing conditions, the Cu0.5 amorphous ribbon not only favors the formation of the amorphous structure, but also enlarges the temperature window for annealing and improves the thermal stability of the α-Fe(Si) phase. At the same time, the Cu0.5 amorphous ribbon shows slow kinetic and is insensitive to heating rate change during annealing treatment. Under isothermal conditions, the addition of Cu decreases the nucleation activation energy (En) and increases the growth activation energy (Eg). This further indicates that the nucleation of α-Fe(Si) grains is easier than the growth process, which is conducive to the formation of a homogeneous nanostructure and improves the soft magnetic properties of the alloy. Compared to Cu0 amorphous ribbon, it is also shown that the Cu0.5 amorphous ribbon changes the crystallization mechanism from diffusion-controlled one-dimensional to two-dimensional growth when the crystallization volume fraction x is 10–30 vol%. While three-dimensional growth become dominated when x is reaches 60 vol% for both ribbons. Therefore, the kinetics of crystallization as well as microstructure supports that the Cu0.5 ribbon is able to exhibit uniformly fine nanocrystalline structures. Further, the Cu0.5 nanocrystalline ribbon shows a higher Bs of 1.85 T and a lower Hc of 2.55 A/m, respectively, and the favorable (100) orientation of α-Fe(Si) grains formed after annealing is another factor to increase Bs.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call