Abstract
Experiments were conducted by eddy current testing of weld zone using a newly developed probe with minimal lift-off-noise. The results have shown that the probe can detect both longitudinal and transversal flaws at the surface in weld zones at reasonable signal to noise ratio when the direction of the probe is properly arranged to the weld. Thus eddy current testing using the new probe is a promising method of non-destructive surface testing of weld zones, replacing magnetic particle testing which is time and cost consuming.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
