Ecotoxicity effect factors for plastic additives on the aquatic environment: New approach for life cycle impact assessment

Abstract

All plastic contains additives. Once in the environment, these will start to leach out and will expose and harm aquatic biota, causing potentially lethal and sub-lethal toxic effects. Even though life cycle assessment covers the toxic impacts of several thousands of chemicals, models to assess the toxic impacts of plastic additives are only emerging. We gathered 461 data points from the literature (266 for freshwater and 195 for marine ecosystems) for 75 species belonging to 9 different phyla. The endpoints effective concentration and lethal concentration, no observed effects concentrations and lowest observed effect concentration tested in acute and chronic exposure, were harmonized into chronic values by applying extrapolation factors. The collected data points covered 75 main plastic additives. This allowed us to calculate 25 Effect factors, 19 for single chemicals and four for overarching categories (alkylphenols, benzophenones, brominated flame retardants and phosphates. In addition, we calculated an aggregated effect factor for chemicals that did not fit in any of the previous groups, as well as a Generic effect factor including 404 gathered data points. The estimated potentially affected fraction (PAF) for the single additives varied between 20.69 PAF·m3·kg−1 for diethyl phthalate and 11081.85 PAF·m3·kg−1 for 4-Nonylphenol. The factors can in future be combined with fate and exposure factors to derive a characterization factor for toxicity caused by additives in aquatic species. This is an important advancement for the assessment of the impacts of plastic debris on aquatic species, thus providing information for decision-makers, as well as guiding policies for the use of additives, ultimately aiming to make the plastic value chain more sustainable.