Abstract
Traditional phase I trials are designed to be conservative. Many times a traditional phase I trial design stops at a dose level below the maximal tolerated dose (MTD), thus potentially treating patients at a suboptimal level in all subsequent trials. This has been confirmed by our recent simulation studies. We propose a phase I/II trial design to determine the most promising dose level in terms of toxicity and efficacy for cytostatic or targeted agents. This design evaluates three dose levels for efficacy and toxicity using a modified phase II selection design. The dose levels include the phase I recommended dose (RD) in addition to the dose levels immediately below and above that level. This phase I/II trial design uses a two-step approach. In the first step, a traditional phase I trial design is used to get close to a good dose level. The second step consists of a modified selection design, randomizing patients to three dose levels: the phase I RD level and the dose levels immediately below and above the phase I RD level. Both efficacy and toxicity are used to determine a good or best dose level. Appropriate toxicity stopping rules in the phase II portion of the trial are implemented as part of such a trial. We perform simulation studies for a variety of toxicity and efficacy scenarios to determine the operating characteristics of this design and compare those to our originally proposed trial where we only explore dose levels at and below the phase I RD in the second phase of the trial, as well as to the traditional setting where a phase I trial is followed by a single-arm phase II trial at the phase I RD. The 3-arm modified selection design exploring the dose levels immediately above and below as well as the RD performs as well or better than the 2-arm modified selection design or the single-arm design for almost all toxicity and efficacy scenario combinations tested. We demonstrate that this design has a higher success rate at identifying a good or best dose level when exploring dose levels immediately above and below the RD in the early phase II setting, in most cases without needing larger sample sizes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have