E-90-P COMPARATIVE TEST OF HAMMER MILL PULVERIZER AND DRY PAN FOR CRUSHING STREATOR SHALE1

Abstract

In the machines as described below the following points are discussed: (1) the grinding action, (2) energy consumption per ton ground, (3) capacity to produce fines six-mesh and under, (4) to determine the operating characteristics of the hammer mill. The conclusions given are: (1) The dry pan will not grind shale chunks larger than 15 inches maximum diameter, nor chert nodules of any size. The hammer mill grinds easily in one operation all chunks small enough to go through the 20 × 42-inch hopper opening and all chert nodules. (2) The energy consumption of the dry pan as compared to the hammer mill in kw. hrs. per ton of fines through six-mesh is approximately as 1.40 to 1.25. (3) The maximum capacity of the Frost %foot dry pan with 1/4-inch screen plate openings was known to be approximately 25 tons through six-mesh per hour. The maximum capacity of the 30 × 42-inch Williams hammer mill as reached in these tests with hand feeding was found to be 56 tons total feed and 42 tons through six-mesh per hour. This figure could have been greatly exceeded if the material could have been fed more rapidly. The dry pan tailings coarser than six-mesh compared to the hammer mill tailings of the same coarseness are as 40 to 25%. (4) The hammer mill is more efficient than the dry pan in practically all respects if properly set up and operated, but it is easily possible to secure less efficient results from the hammer mill, particularly if the feeding is not properly regulated.