Abstract

Abstract. The properties of the subduction interplate domain are likely to affect not only the seismogenic potential of the subduction area but also the overall subduction process, as it influences its viability. Numerical simulations are performed to model the long-term equilibrium state of the subduction interplate when the diving lithosphere interacts with both the overriding plate and the surrounding convective mantle. The thermomechanical model combines a non-Newtonian viscous rheology and a pseudo-brittle rheology. Rock strength here depends on depth, temperature and stress, for both oceanic crust and mantle rocks. I study the evolution through time of, on one hand, the brittle-ductile transition (BDT) depth, zBDT, and, on the other hand, of the kinematic decoupling depth, zdec, simulated along the subduction interplate. The results show that both a high friction and a low ductile strength at the asthenospheric wedge tip shallow zBDT. The influence of the weak material activation energy is of second order but not negligible. zBDT becomes dependent on the ductile strength increase with depth (activation volume) if the BDT occurs at the interplate decoupling depth. Regarding the interplate decoupling depth, it is shallowed (1) significantly if mantle viscosity at asthenospheric wedge tip is low, (2) if the difference in mantle and interplate activation energy is weak, and (3) if the activation volume is increased. Very low friction coefficients and/or low asthenospheric viscosities promote zBDT = zdec. I then present how the subducting lithosphere age affects the brittle-ductile transition depth and the kinematic decoupling depth in this model. Simulations show that a rheological model in which the respective activation energies of mantle and interplate material are too close hinders the mechanical decoupling at the down-dip extent of the interplate, and eventually jams the subduction process during incipient subduction of a young (20-Myr-old) and soft lithosphere under a thick upper plate. Finally, both the BDT depth and the decoupling depth are a function of the subducting plate age, but are not influenced in the same fashion: cool and old subducting plates deepen the BDT but shallow the interplate decoupling depth. Even if BDT and kinematic decoupling are intrinsically related to different mechanisms of deformation, this work shows that they are able to interact closely. Comparison between modelling results and observations suggests a minimum friction coefficient of 0.045 for the interplate plane, even 0.069 in some cases, to model realistic BDT depths. The modelled zdec is a bit deeper than suggested by geophysical observations. Eventually, the better way to improve the adjustment to observations may rely on a moderate to strong asthenosphere viscosity reduction in the metasomatised mantle wedge.

Highlights

  • The subduction interplate domain is an interface of seismogenic coupling at the time scale of one seismic cycle, and of kinematic decoupling on long-term geological time scales

  • Even if brittle-ductile transition (BDT) and kinematic decoupling are intrinsically related to different mechanisms of deformation, this work shows that they are able to interact closely

  • For an old subducting lithosphere, the brittleductile transition depth mainly depends on the friction coefficient and the activation energy of the interplate material; i.e. high friction and low activation energy shallow the BDT

Read more

Summary

Introduction

The subduction interplate domain (considered either as a plane or a channel, depending on the setting) is an interface of seismogenic coupling at the time scale of one seismic cycle, and of kinematic decoupling on long-term geological time scales. The properties of this very particular interface are likely to affect the seismogenic potential of the subduction area and the overall subduction process, as it influences its viability. The subduction channel, and could depend on many variables such as temperature, pressure, compositional variations, strain rate, etc This implies a self-consistent equilibrium state of the subduction interplate, whose characteristics would depend on the subduction setting. Numerical simulations of subduction dynamics appear as one of the more powerful tools to try to unravel the physics of the interplate dynamics

Modelling the subduction interplate in simulations of convergence
Model setup
Mechanical boundary conditions and subduction modelling
C10 C10LG C12 C13 C13HG C13f14 C14b C6 C10 C12 C12 C13 C13 C13 C13f14 C14b
Rheological model
Choice of rheological parameter sets
Numerical resolution
Interplate dynamics for an old incoming lithosphere
Estimate of zBDT and zdec
Rheological parameters controlling the brittle-ductile transition depth
Rheological parameters controlling the interplate decoupling depth
Va increase
Interplate dynamics for a young incoming lithosphere
Consequences for subduction initiation and perennity
Friction coefficient along the interplate shear zone
C12 C6 -C13f14
BDT and subduction decoupling depth in nature
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call