Abstract
By means of a graft scheme, a buck‐boost cell and a wide range diagonal half‐bridge flyback cell are combined to create a novel single‐stage high power factor correction (HPFC) diagonal half‐bridge flyback ac/dc converter in this paper. When both of the two cells operate in discontinuous conduction mode, the proposed converter exhibits high power factor and low bulk capacitor voltage stress independent of the load variations. Based on the Loss‐Free Resistor (LFR) model, a new technique, referred to as ac‐dc balancing method, is also proposed. It is useful to determine the dc values, voltage ripples, and phase angle shifts of the bulk capacitor and output voltage of the converter. Moreover, the component values are well designed according to the operation conditions and design specifications of the converter. Finally, a prototype of the proposed converter with output voltage 48 V and power 100 W is built to test the theoretical analysis. It is successfully validated by IsSpice simulations and experimental results.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
