Abstract

In the present research, application of the Natural Orthogonal Complement (NOC) for the dynamic analysis of a spherical parallel manipulator, referred to as SST, is presented. Both inverse and direct dynamics are considered. The NOC and the SST fully parallel robot are explained. To drive the NOC for the SST manipulator, constraints between joint variables are written using the transformation matrices obtained from three different branches of the robot. The Newton–Euler formulation is used to model the dynamics of each individual body, including moving platform and legs of the manipulator. D’Alembert’s principle is applied and Newton–Euler dynamical equations free from non-working generalized constraint forces are obtained. Finally two examples, one for direct and one for inverse dynamics are presented. The correctness and accuracy of the obtained solution are verified by comparing with the solution of the virtual work method as well as commercial multi-body dynamics software.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.