Dynamic Simulation Platform Aids Deep Transient Tests, Well-Control Safety

Abstract

_ This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 215454, “Enhancing Well-Control Safety With Dynamic Well-Control Cloud Solutions: Case Studies of Successful Deep Transient Tests in Southeast Asia,” by M. Ashraf Abu Talib, SPE, M. Shahril Ahmad Kassim, and Izral Izarruddin Marzuki, SPE, Petronas, et al. The paper has not been peer reviewed. _ The complete paper addresses challenges related to well control and highlights the successful implementation of deep transient tests (DTT) in an offshore well performed with the help of a dynamic well-control simulation platform. The paper aims to provide insights into the prejob simulation process, which ensured a safer operation from a well-control perspective. Additionally, a comparison between simulated and actual sensor measurements during the DTT operation is presented. DTT DTT is a formation-testing (FT) method that allows pressure transient tests that reach deeper into the formation compared with conventional interval pressure transient tests (IPTT). DTT enables the testing of formations with higher permeability, greater thickness, and lower viscosity and real-time measurement of crucial parameters. During a DTT, formation fluid is pumped from the reservoir; upon stopping the pump, the formation pressure begins to recover as fluid further from the wellbore replaces the extracted fluid. By analyzing the resulting pressure transient, properties such as formation permeability, permeability anisotropy, and other characteristics can be determined. DTT allows for a better understanding of reservoir characteristics and rock heterogeneity. When properly designed and executed, DTT can reveal potential baffles and boundaries within the radius of investigation. A further advantage of DTT over drillstem tests (DST) is its minimal fluid flow, which allows for the attainment of objectives while contributing to the United Nations sustainable development goals. In DTT operations, the FT tool is connected to the drillpipe through a circulating sub and a slip joint. The circulating sub plays a critical role in DTT operations because it enables the continuous mixing of pumped formation fluid with circulated mud and facilitates its transportation to the surface (Fig. 1). Typically, a constant circulation rate ranging from 100 to 250 gal/min is maintained. During circulation, the annular preventer is closed and the mud/hydrocarbon mixture is directed through the choke line to the mud/gas separator (MGS) once it reaches the surface. No formation fluids are flared during DTT operations. Instead, the circulated oil is retained in the mud and only small amounts of gas are vented. By use of a slip joint, the FT remains anchored to the borehole wall. A high-resolution pressure gauge is used to capture and interpret even minor pressure fluctuations during the pressure transient buildup.