Abstract
Based on the proper improvement and development of the basic principle of digital image correlation method, a 3D-DIC measurement system is built. Its measurement principle and application process can be divided into four steps: camera calibration, image acquisition, image matching and three-dimensional reconstruction. The measurement system can realize non-contact and full-field measurement and has the advantages of not being affected by the test environment, not imposing additional mass on the test model, and high signal-to-noise ratio of the measured data. Taking the elastic plate model as an example, the accuracy and reliability of the measurement system in the measurement of static and dynamic displacement response are verified by using the measurement results of laser displacement meter as a reference. In addition, the tensile strain of the projectile aluminum alloy tail model and the ground mode of the elastic plate are tested to further verify the practicability of the test system.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
