Abstract
In this paper, dynamic response of 1-inch hard disk drive (HDD) head arm assembly (HAA) against an impact load is obtained by means of a 3D non-linear finite element model in ANSYS/LS-DYNA and experiments using Optical method. A mass is modeled as a rigid body and is made to collide with the arm. The velocity, displacement, acceleration and the inertial force of the mass are obtained from the time- history of finite element analysis (FEA). In the experiment, a mass that is levitated with an aerostatic linear bearing, and hence encounters negligible friction, is made to collide with the HAA and the dynamic bending test for the arm is realized. During the collision the Doppler frequency shift of the laser beam reflecting from the mass is accurately measured using an optical interferometer. The velocity, the position, the acceleration and the inertial force of the mass are calculated from the measured time-varying Doppler frequency shift. A good correlation between the experimental data and FEA results is observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
