Dynamic recrystallization of wet synthetic polycrystalline halite: dependence of grain size distribution on flow stress, temperature and strain

Abstract

Listen

Translate article

It is often observed that dynamic recrystallization results in a recrystallized grain size distribution with a mean grain size that is inversely related to the flow stress. However, it is still open to discussion if theoretical models that underpin recrystallized grain size–stress relations offer a satisfactorily microphysical basis. The temperature dependence of recrystallized grain size, predicted by most of these models, is rarely observed, possibly because it is usually not systematically investigated. In this study, samples of wet halite containing >10 ppm water (by weight) were deformed in axial compression at 50 MPa confining pressure. The evolution of the recrystallized grain size distribution with strain was investigated using experiments achieving natural strains of 0.07, 0.12 and 0.25 at a strain rate of 5×10 −7 s −1 and a temperature of 125 °C. The stress and temperature dependence of recrystallized grain size was systematically investigated using experiments achieving fixed strains of 0.29–0.46 (and one to a strain of 0.68) at constant strain rates of 5×10 −7–1×10 −4 s −1 and temperatures of 75–240 °C, yielding stresses of 7–22 MPa. The microstructures and full grain size distributions of all samples were analyzed. The results showed that deformation occurred by a combination of dislocation creep and solution-precipitation creep. Dynamic recrystallization occurred in all samples and was dominated by fluid assisted grain boundary migration. During deformation, grain boundary migration results in a competition between grain growth due to the removal of grains with high internal strain energy and grain size reduction due to grain dissection (i.e. moving boundaries that crosscut or consume parts of neighbouring grains). At steady state, grain growth and grain size reduction processes balance, yielding constant flow stress and recrystallized grain size that is inversely related to stress and temperature. Evaluation of the recrystallized grain size data against the different models for the development of mean steady state recrystallized grain size revealed that the data are best described by a model based on the hypothesis that recrystallized grain size organizes itself in the boundary between the (grain size sensitive) solution-precipitation and (grain size insensitive) dislocation creep fields. Application of a piezometer, calibrated using the recrystallized grain size data, to natural halite rock revealed that paleostresses can vary significantly with temperature (up to a factor of 2.5 for T=50–200 °C) and that the existing temperature independent recrystallized grain size–stress piezometer may significantly underestimate flow stresses in natural halite rock.