Abstract
This paper proposes a 3D graphics simulation environment for the analysis and design evaluation of a layout reconfiguration process of the reconfigurable manufacturing system (RMS). Manufacturing cells (MCs) in the RMS are positioned to minimize a total distance of transport paths for a given manufacturing layout. After the end of current manufacturing process, the MCs start to move to each position in the optimal layout of next manufacturing process. The positioning and timing of the MCs in the reconfiguration process were designed by a reconfigurable process design method based on particle swarm optimization (PSO). From the simulation results, the effectiveness of the reconfiguration process design method based on PSO was confirmed
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.