Dynamic properties of calcareous and siliceous sands under isotropic and anisotropic stress conditions

Abstract

The strain-dependent dynamic properties of sand are generally described by their relative density and mean effective stress, while the contribution of other factors, like soil origin, mineralogy, grain morphology, and initial stress anisotropy, have not been fully recognized. This paper presents the results of an experimental study on the shear modulus and damping ratio of calcareous and siliceous sands of different origins and their identical grain size distribution and stress-density states. Resonant column and cyclic triaxial tests were conducted on reconstituted samples of these two sands obtained from coastal areas. The significance of the initial effective confining pressure and stress anisotropy on the dynamic properties of the sands is evaluated and compared. It is demonstrated that the small-strain shear modulus of the calcareous sand is more affected by an increase in mean effective confining pressure than the siliceous sand. However, the effect of the initial shear on the secant shear modulus of the sands is unique. Based on the test data, a rigorous correction factor is proposed to account for the influence of the initial stress anisotropy on the small-strain shear modulus of the sands. A comparison between the strain-dependent dynamic properties of the calcareous and siliceous sands reveals that the calcareous sand has a higher secant shear modulus, lower damping ratio, and higher linear and volumetric threshold strain. Since the stress-density states and grain size distribution of the two sands were identical in the experiments, the discrepancy in the dynamic properties can be attributed to other factors, including sand origin, grain angularity, mineralogy, and formation processes, which are not commonly taken into account in the current practice.