Abstract
The issue of identification of dynamic parameters in open-chain industrial manipulators is addressed with emphasis on the physical feasibility of the identified set of parameters. The dynamic model on which the identification procedure is based considers rigid-link robots including a complete actuator dynamics modeling and is obtained starting from the Gibbs–Appell equations. Friction at the joints is also considered. The dynamic equations of the model are written linearly with respect to the dynamic parameters to be identified. The matrix form linear system is solved through a quadratic optimization procedure with non-linear constraints in order to ensure the physical feasibility of the identified parameters. The procedure is tested using a PUMA 560 industrial robot. A comparison between control actions and torques obtained from the Inverse Dynamic Problem considering identified parameters is performed in order to establish the validity of the proposed procedure. The set of physically feasible dynamic parameters is used in an integration of the equations of motion of the robot and the results of the simulation are compared with the robot actual movement.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
