Abstract
We have implemented the design of a dual-stage actuator tape head for enhanced reduction of lateral tape motion (LTM) disturbance. Our design consists of a conventional voice coil motor (VCM) and a micro-actuator for coarse and fine positioning, respectively. The micro-actuator, which is mounted on the VCM, uses a piezo crystal and allows following LTM up to the kHz regime, while the VCM follows low frequency LTM. Using step response measurements and a realization algorithm, we have created a multi-input discrete-time model of the dual-stage actuator. Based on the model, we designed and implemented a dual-stage controller, using a dual-input single-output approach based on a PQ method. The dual-stage controller controls the position of both actuators and enables an increased track-following bandwidth along with a control signal that is smaller in magnitude than that for a conventional single-stage tape head.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.