Dynamic Load Analysis of Mine-Truck Using Multibody Dynamic Analysis Method

Abstract

Abstract: Vehicle load distributed on front & rear axle assembly during various working conditions is one of the most important factors influencing working performance and service life of drive axle assembly. The dynamic load on axle assembly is higher compared to the rated load because of variations in vehicle speed and road surface conditions. Early failure of structural components is caused because of higher dynamic reaction forces due to uneven road profiles. The dynamic load calculation of axle assembly is presented in this paper for a Mine-truck with various road conditions and vehicle speeds. The road load conditions consist of grade, bump & path hole. Mine-truck with payload capacities of 63 Ton is considered for the study. The behaviour of vertical force is calculated for different vehicle speeds (3 - 12 km/hr.) of the machine on the front & rear axle assembly during running conditions. Multi-body dynamic Analysis tool ADAMS is used for this study. ADAMS helps to study the dynamics of moving parts and load distribution throughout mechanical systems during motion. The Mine-truck3D model was created with the help of computer-aided design (CAD) software. Major units of Mine trucks are considered to prepare 3D models like Cabin-engine mass, Bucket, front axle assembly, rear Axle assembly & tires. Multi-body vehicle models are prepared in simulation software ADAMS by importing 3D models prepared by computer-aided design (CAD) software. This provides guidelines for selecting dynamic load factors while designing structural parts of the vehicle.