Abstract

This study focused on the dynamic hydrogen production ability of a core@shell-structured CuS@TiO2photocatalyst coated with a high concentration of TiO2particles. The rectangular-shaped CuS particles, 100 nm in length and 60 nm in width, were surrounded by a high concentration of anatase TiO2particles (>4~5 mol). The synthesized core@shell-structured CuS@TiO2particles absorbed a long wavelength (a short band gap) above 700 nm compared to that pure TiO2, which at approximately 300 nm, leading to easier electronic transitions, even at low energy. Hydrogen evolution from methanol/water photo-splitting over the core@shell-structured CuS@TiO2photocatalyst increased approximately 10-fold compared to that over pure CuS. In particular, 1.9 mmol of hydrogen gas was produced after 10 hours when 0.5 g of 1CuS@4TiO2was used at pH = 7. This level of production was increased to more than 4-fold at higher pH. Cyclic voltammetry and UV-visible absorption spectroscopy confirmed that the CuS in CuS@TiO2strongly withdraws the excited electrons from the valence band in TiO2because of the higher reduction potential than TiO2, resulting in a slower recombination rate between the electrons and holes and higher photoactivity.

Highlights

  • In recent years, hydrogen has been highlighted as a nextgeneration energy source because of its environmentally friendly nature and high-energy efficiency

  • The relationship between the spectroscopic properties and the catalytic performance for the hydrogen production over the core@shell-structured CuS@TiO2 was examined by X-ray diffraction (XRD), transmission electron microscopy (TEM), UV-visible absorption spectroscopy, Brunauer, Emmett, and Teller (BET) surface areas, cyclic voltammetry (CV), and zeta potential measurements using an electrophoresis measurement apparatus

  • In the case of CuS@TiO2, the peaks for crystalline CuS almost disappeared except for a very small peak at 33.03∘ 2θ (006). This result coincides with the fact that in general if the core-shell structure formed completely in a core-shell material, the XRD peaks for the core do not appear; only the diffraction patterns for the shell are observed [27]

Read more

Summary

Introduction

Hydrogen has been highlighted as a nextgeneration energy source because of its environmentally friendly nature and high-energy efficiency. Studies of metal sulfide photocatalysts, such as ZnS- [8], CuS- [9, 10], FeS[11], Bi2S3- [12], Sb2S3- [13], or CdS-loaded TiO2 [14], have covered topics ranging from synthesis to applications in new photocatalytic reaction mechanisms. A previous study reported high photocatalytic activity on the ZnS-loaded TiO2 composite system for hydrogen. The relationship between the spectroscopic properties and the catalytic performance for the hydrogen production over the core@shell-structured CuS@TiO2 was examined by X-ray diffraction (XRD), transmission electron microscopy (TEM), UV-visible absorption spectroscopy, Brunauer, Emmett, and Teller (BET) surface areas, cyclic voltammetry (CV), and zeta potential measurements using an electrophoresis measurement apparatus

Experimental
Results and Discussion
Sample CuS TiO2
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call