Abstract
Laser forming is, potentially, an attractive flexible manufacturing technique for the controlled forming of aerospace alloys. Laser forming experiments using a continuous-wave CO2 laser were performed on coupons of material 80 mm × 80mm in area and 2mm thick, with sequential passes of the laser beam, at a surface scanning rate of 20 mm/s with 90 s of convective cooling between passes. A novel surface profilometer that was specifically developed to operate under the conditions of high vibration and stray light typically found in laser machining applications recorded transient surface shape changes during individual laser passes at frame rates of 4 and 0.2 Hz. A finite element model was developed using ABAQUS for the laser forming of linear bends in free Ti-6A1-4V sheets, with sequentially coupled thermal and elastic-plastic analysis incorporating temperature-dependent material properties. Transient heat source scanning was implemented to simulate the experiment. Good agreement was found between the experimental three-dimensional shape data and those predicted by the transient model. In particular, the formation of an unwanted ‘camber’ distortion perpendicular to the desired main bend was correctly predicted; its magnitude and temporal evolution throughout the three laser passes, and during the periods of convective cooling, agreed well with the experimental data. The model and the shape measurement technique will enable the future predictive controlled laser forming of more complex three-dimensional shapes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.