Abstract
Solution to the problem of improvement in the efficiency of material cutting equipment is an important task in the development of modern mechanical engineering and related areas of science and technology. Various material cutting methods are available at present: mechanical, hydromechanical (hydroabrasive), electrical discharge, plasma, laser, and others. Further improvement in the efficiency of the operation of material cutting equipment is related to the development of rapid methods and tools for monitoring the efficiency of cutting processes. The existing strain gauge means for monitoring the cutting power of materials are limited by the output signal frequency of up to 100 kHz. High-speed control of the efficiency of cutting processes can be carried out on the basis of the developed dynamic method and traditional controls of high-performance material processing equipment with an output signal frequency of up to 1 MHz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
