Abstract
Low carbon, high strength steel alloys such as Vascomax steels are used in a wide variety of extreme environments due to their high strength, high fracture toughness, and stability over a wide range of temperatures. In this study, Vascomax® C250 steel was dynamically characterized in compression using Kolsky compression bar techniques at two strain rates of 1000 and 3000 s-1. A pair of impedance-matched tungsten carbide platens were implemented to protect damage to the bar ends. The tungsten carbide platens were experimentally calibrated as system compliance which was then properly corrected for actual specimen strain measurements. In addition, elastic indentation of the high-strength compression sample into the platens was also evaluated and showed negligible effect on the specimen strain measurements. The Vascomax® C250 steel exhibited strain-rate effects on the compressive stress-strain curves. The dynamic yield strength was approximately 18% higher than quasi-static yield strength obtained from hardness tests. The dynamic true stress-strain curves of the Vascomax® C250 steel in compression were also computed and then compared with the previously obtained true tensile stress-strain curves at the same strain rates. The Vascomax® C250 steel exhibited a reasonable symmetry in dynamic compression and tensile stress-strain response. However, the fracture strains in dynamic compression were smaller than those in dynamic tension probably due to different fracture mechanisms in the different loading modes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have