Dynamic Anion Delocalization of Single-Ion Conducting Polymer Electrolyte for High-Performance of Solid-State Lithium Metal Batteries

Abstract

Listen

Translate article

Lithium metal batteries (LMBs) have been considered as next-generation energy storages due to their extremely high theoretical specific capacity (3860 mAh g-1). However, current LMBs, using conventional liquid electrolytes, still could not fulfill the demand of soaring expansion of energy era, such as electrical vehicles, because of their safety issues, originated by uncontrollable electrolytic side reaction on the lithium, resulting unstable solid-electrolyte interphase (SEI) and vicious lithium dendritic growth [1]. Also, carbonate-based liquid electrolytes have an intrinsic flammability, and the lithium dendrite, which short-circuits a cell, can lead to severe safety hazard with the unfavorable flammability of current liquid system when they are ignited. Therefore, solid-state electrolytes have been spotlighted recently for a pathway for safe, and high energy and power LMBs, due to their superior thermal stability and low vapor pressure, while maintaining suitable electrolytic performances.In this study, solid-state single-ion conducting polymer electrolytes (SICPEs), utilizing dynamic anion delocalization (DAD), realizing high ionic conductivity and dimensional stability for high-performance LMB, are studied. The SICPEs enable superior lithium transference number, resulting in highly reduced concentration gradient of lithium cation along the electrolyte to suppress the undesirable lithium dendritic growth. However, SICPEs have prominently lower ionic conductivity than dual-ion conducting polymer electrolyte (DICPEs), which is a critical issue to make a slower charge/discharge for SICPEs [2]. Although an approach utilizing gel polymer electrolyte (GPE), using a liquid solvent as a plasticizer, has been exploited to increase the ionic conductivity of SICPEs, GPEs have struggled with lower mechanical stability, compared to solid state, and still existing flammability issue with the plasticizer. The novel plasticizer, which is described here, can interact with bulky anionic polymer matrix, so that the negative charge can be dispersed onto the whole complex by DAD. Once the bulky complex is formed by DAD, the dissociation of lithium cation from anionic matrix can be easier with the decreased activation energy and higher ionic conduction. While increasing the ionic conductivity with DAD, the nature of polymeric plasticizer will highly suppress flammability. DAD allows the membrane endure more tensile strength due to the dynamic structural change in crosslinking state, so that the polymer electrolyte can tolerate dendritic growth of lithium by morphological change on an electrode surface.The obvious advantages of DAD-induced solid polymer electrolytes in this study for a high energy and power, and ultra-safe LMB can present a novel approach of polymer electrolyte design to the astronomical demand of energy storages.[1] F. Ahmed, I. Choi, M.M. Rahman, H. Jang, T. Ryu, S. Yoon, L. Jin, Y. Jin, W. Kim, ACS Appl. Mater. Interfaces 2019, 11, 34930-34938.[2] D.-M. Shin, J.E. Bachman, M.K. Taylor, J. Kamcev, J.G. Park, M.E. Ziebel, E. Velasquez, N.N. Jarenwattananon, G.K. Sethi, Y. Cui, J.R. Long, Adv. Mater. 2020, 32, 1905771.