Abstract

Aims. We compare the far-infrared to sub-millimetre dust emission properties measured in high Galactic latitude cirrus with those determined in a sample of 204 late-type DustPedia galaxies. The aim is to verify if it is appropriate to use Milky Way dust properties to derive dust masses in external galaxies. Methods. We used Herschel observations and atomic and molecular gas masses to estimate ϵ(250 μm), the disc-averaged dust emissivity at 250 μm, and from this, the absorption cross section per H atom σ(250 μm) and per dust mass κ(250 μm). The emissivity ϵ(250 μm) requires one assumption, which is the CO-to-H2 conversion factor, and the dust temperature is additionally required for σ(250 μm); yet another constraint on the dust-to-hydrogen ratio D/H, depending on metallicity, is required for κ(250 μm). Results. We find ϵ(250 μm) = 0.82 ± 0.07 MJy sr−1 (1020 H cm−2)−1 for galaxies with 4 < F(250 μm)/F(500 μm) < 5. This depends only weakly on the adopted CO-to-H2 conversion factor. The value is almost the same as that for the Milky Way at the same colour ratio. Instead, for F(250 μm)/F(500 μm) > 6, ϵ(250 μm) is lower than predicted by its dependence on the heating conditions. The reduction suggests a variation in dust emission properties for spirals of earlier type, higher metallicity, and with a higher fraction of molecular gas. When the standard emission properties of Galactic cirrus are used for these galaxies, their dust masses might be underestimated by up to a factor of two. Values for σ(250 μm) and κ(250 μm) at the Milky Way metallicity are also close to those of the cirrus. Mild trends of the absorption cross sections with metallicity are found, although the results depend on the assumptions made.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.