Abstract
This paper describes the concept of a dust monitor using lead zirconate titanate (PZT) ceramics with a large detection area. Its potential as a dust detector is experimentally demonstrated. The dust monitor has a small volume compared to an impact ionization detector with the same detection area, due to the PZT sensor. The PZT sensor, as a traditional device for the in-situ observation of hypervelocity dust particles, has been used for momentum measurement. The hypervelocity impact signals of PZT sensors are typically read by charge-sensitive amplifiers. Instead, we suggest a new method that a current-to-voltage converting amplifier is useful for interpreting the impact signal of a PZT sensor arising from dust particles down to 0.5 μm in radius. We propose that datasets of dust impacts can be obtained with a higher statistical accuracy, if the new method is applied to instruments on forthcoming interplanetary-space-cruising spacecrafts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.