Abstract
Hypersaline solution with high TDS is not suitable for direct treatment by the conventional membrane and thermal processes. The current study proposes a dual-stage FO/PRO process for hypersaline solution treatment and power generation. The treatment process reduces the concentration of saline wastewater and hence renders it suitable for disposal directly to sea or treatment by the conventional membrane and thermal processes. The draw and feed solutions in the FO process were the hypersaline solutions and wastewater effluent, respectively. Five concentrations were evaluated for the process treatment with different concentrations ranging from 53g/L to 157g/L. The performance of FO membrane was estimated using pre-developed computer software. The results showed that a higher power can be generated from the PRO-FO system than from the FO-PRO system without compromising the concentration of hypersaline solution after dilution. The study also showed that although increasing the flow rate of draw solution resulted in an increase in the permeate flow rate, it caused a reduction in the dilution of draw solution. On the other hand, the study showed a negligible improvement in the performance of FO membrane upon increasing the feed solution flow rate. Finally, the simulation results showed that the concentration of diluted draw solution was suitable for the conventional membrane and thermal treatments or discharge to seawater after the dual-stage FO membrane treatment.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.