Dual-comb optical parametric oscillator in the mid-infrared based on a single free-running cavity.

Abstract

We demonstrate a free-running single-cavity dual-comb optical parametric oscillator (OPO) pumped by a single-cavity dual-comb solid-state laser. The OPO ring cavity contains a single periodically-poled MgO-doped LiNbO3 (PPLN) crystal. Each idler beam has more than 245-mW average power at 3550 nm and 3579 nm center wavelengths (bandwidth 130 nm). The signal beams are simultaneously outcoupled with more than 220 mW per beam at 1499 nm and 1496 nm center wavelength. The nominal repetition rate is 80 MHz, while the repetition rate difference is tunable and set to 34 Hz. To evaluate the feasibility of using this type of source for dual-comb applications, we characterize the noise and coherence properties of the OPO signal beams. We find ultra-low relative intensity noise (RIN) below -158 dBc/Hz at offset frequencies above 1 MHz. A heterodyne beat note measurement with a continuous wave (cw) laser is performed to determine the linewidth of a radio-frequency (RF) comb line. We find a full-width half-maximum (FWHM) linewidth of around 400 Hz. Moreover, the interferometric measurement between the two signal beams reveals a surprising property: the center of the corresponding RF spectrum is always near zero frequency, even when tuning the pump repetition rate difference or the OPO cavity length. We explain this effect theoretically and discuss its implications for generating stable low-noise idler combs suitable for high-sensitivity mid-infrared dual-comb spectroscopy (DCS).