Dual Outputs Switch Mode Power Supply (DOSMPS) Utilizing Forward Converter Topology

Abstract

Experimental works of dual, 5 volt DC outputs switch mode power supply (DOSMPS) is presented in this paper. To design, construct and evaluate the DOSMPS using forward converter topology are the objectives of this article. In this work, a 556 timer was picked as the pulse width modulator. The 556 timer was picked because it is widely used, cheap and capable of producing stable dual pulse width modulations. Since, this work targeted dual DC outputs, two forward converter circuits were built. However, switching frequencies at two transistors were controlled by only one 556 timer. The complete circuit of the DOSMPS consist of full bridge rectifier, smoothing capacitor, two high frequency transformers and two forward converter circuits. At the first stage of this work, the DOSMPS circuit was designed using Proteus software. Later, the complete DOSMPS circuit was constructed on two breadbroads after all of the electronic components and devices were available. Important parameters such as the input and output voltages and duty cycles were measured using digital oscilloscope and multimeter. Results from these measurements have shown that the designed circuit can convert single-phase 24 Vrms 50 Hz AC voltage input into dual and stable 5±0.1 V DC outputs. Also from this work, it was observed that, pulsed DC voltages with peak value of 2 V and frequency less than 20 kHz are sufficient in controlling the switching frequencies of both BJT transistors. This allows the regulation of the output voltage within the desired range. Analysis carried out after the measurements has shown close correlation between the theoretical and experimental results, where the calculated and measured switching frequencies had only deviated by 1.1%.