Abstract
Aiming at the current control steady‐state error caused by sampling delay, parameters mismatch of direct‐drive permanent magnet synchronous motor (PMSM). This paper proposed a method of dual model predictive control (MPC) of direct‐drive PMSM based on sliding mode disturbance observer (SMDO). Deadbeat predictive current control (DPCC) is used for current loop, a SMDO is proposed to observe the system disturbance, the estimation is compensated to DPCC by feedback to decrease the current control steady‐state error. For speed loop, MPC with an internal model control observer (IMCO) can observe and compensate the load disturbance feedforward. The experimental results show that, the dynamic response speed of the proposed strategy is fast, the speed recovery time after sudden load torque is short, and the anti‐load disturbance performance and current tracking performance are effectively improved. © 2024 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEJ Transactions on Electrical and Electronic Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
