Abstract
There are many commercial applications, such as mobile radio and wireless communications that use microstrip antennas. Microstrip antennas however have limitations in size, bandwidth, and efficiency. On the other hand, the dielectric resonator (DR) antenna is attractive due to its small-size, high radiation efficient, and ease of excitation.[1-3] Three dielectric properties of materials must be considered for DR antenna used: a high permittivity, a high quality factor, and a near zero temperature coefficient of resonant frequency. The size of the DR antenna decreases with increasing the permittivity of the dielectric resonator. The quality factor is representative of the antenna losses. Typically there are radiation, conduction, dielectric, and surface wave losses. Therefore the total quality factor is influenced by these losses. The DR antenna offers very high radiation efficiency due to its low dielectric loss and it has no metallic loss. A near zero temperature coefficient of resonant frequency are for high temperature stability. In traditionally, the DR with relatively small permittivity around 10 is chosen for DR antenna to enhance the radiation capability.[4-10] However, low profile DR antenna with relatively low resonant frequency can be achieved by using high permittivity. Recently, dual band antenna has been implemented for applications in WLAN (wireless local area network, 2.4–2.484 GHz), ISM (Industrial, Scientific, Medical) and Bluetooth at low band. Additionally, the dual band antenna can be applied at high band, such as HIPERLAN (high-performance radio local area network, 5.15–5.35 GHz) and Unlicensed National Information Infrastructure (UNNI) applied. In this paper, we present the design of a dual band hybrid antenna consists of a rectangular slot and a circular disk high permittivity dielectric resonator for operating at the ISM band and UNNI band. Details of the proposed antenna and experimental results are present. The characteristics of dual band hybrid antenna, such as return loss, input impedance, radiation pattern, and gain, have been measured and discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have