Abstract
When rain impacts a building façade, it is essential that once it has entered, it leaves by evaporation to help the building dry out. Accumulation of moisture can lead to internal dampness, mould and decay of valuable masonry by salt weathering. In a solid masonry wall where the stone is of low permeability, such as granite which is found in many historic buildings, rain water mainly enters and leaves through mortar joints. If granite stone masonry needs repointing, the repair mortar must allow the overall masonry to dry out. This study evaluates the drying response of various lime-based repointing mortars mixes in small granite stone masonry constructions (test walls) subjected to a simulated intense short rain event and then left to dry. It determines the moisture movement through mortar joints, the influence of materials, joint types and workmanship, and whether repointing could mitigate moisture ingress and help masonry dry out. This study developed a novel experimental protocol which allowed comparison of the drying response of different mortar types in a low-porosity stone masonry system and the effect of repointing. Five test walls were built of Cornish granite with five different lime mortar mixes combining NHL 3.5 (St Astier) gauged with non-hydraulic quicklime (Shap), quartz and calcitic sand and biomass wood ash as additives. Simulated intense rain was sprayed on each wall over a 3.25 h spell. Drying was monitored over a week with a microwave moisture device (MOIST350B). Measurements were done at surface and depth on both mortar joints and granite units. Each wall was then repointed with the same mortar mix initially used when built and the same rain simulation was performed to evaluate differences repointing could make to the moisture dynamics. The importance of mortar in dealing with moisture movements in the test wall and absorbing moisture from the stones was demonstrated. Gauged binder and wood ash additives decreased the capillary absorption capacity of mortars while retaining a good drying rate. This study has also showed that after repointing water did not penetrate as deep under the same conditions. Therefore repointing reduces the threat of water ingress and shows that it could be a suitable conservation intervention to mitigate water ingress and accelerate drying.
Highlights
Many historic and traditional solid masonry walls in England and other temperate maritime environments are exposed to high amounts of rainfall and wind-driven rain [1]
This study found that moisture movement in and out of a masonry test walls made of low-porous units clearly occurred though the mortar joints (Fig. 5)
A comprehensive experiment was designed to assess the response to an intense rainfall event of different building materials within a specific masonry system—lime mortar and granite, at two levels—surface and depth, and two timeframes—at absorption and over a week of drying and evaporation
Summary
Many historic and traditional solid masonry walls in England and other temperate maritime environments are exposed to high amounts of rainfall and wind-driven rain (driving rain) [1]. Most of the moisture movement occurs through mortar joints in a solid ashlar masonry wall. This is especially true for stone units of low permeability and low-porosity, such as granite, where rain water mainly enters and leaves through mortar joints [12,13,14]. If most of the evaporation occurs at the surface of the joints, so will any salt crystallisation and efflorescence This will minimise damage to the individual stones, such as disintegration. Climate change is expected to cause more driving rain and which will increase the threats to masonry structure, mainly due to salt crystallisation [17, 18]. The role and performance of mortar in absorbing moisture is becoming even more important
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
