Dry sliding wear of aluminium-high silicon hypereutectic alloys

Abstract

One of the main limitations on using aluminium-high silicon (with silicon contents greater than about 20wt%) alloys is the formation of coarse, brittle silicon particles under conventional solidification conditions. However, an increase in silicon content generally gives an improvement in wear properties so there is a drive to produce the high silicon alloys with relatively fine microstructures. Rapid solidification processing (RS) is very effective in limiting the coarsening of primary silicon due to the high cooling rate. Here flakes of material produced by chopping melt-spun ribbon have been degassed, consolidated, hot isostatically pressed and then extruded. The resulting material has been subjected to dry sliding reciprocating multi-pass wear testing at room temperature against a steel ball bearing at 10N and 100N load. The alloys compared can essentially be characterised as ‘low in silicon (around 21wt%), high in intermetallic-forming elements (Fe, Cu, Ni)’ and ‘high in Si (around 30wt% Si), low in intermetallic forming elements’. The wear results show that extruded bar with composition Al 21Si 3.9Cu 1.2Mg 2.4Fe 1.4Ni 0.4Zr has higher hardness, and hence wear resistance, than extruded bar with composition Al 29.8Si 1.3Cu 1.4Mg 0.3Fe 0.3Ni 0.3Zr, despite the higher Si content. It is thought that, at the higher Si content, there may be silicon particle pull-out which may subsequently lead to a three-body abrasive wear mechanism. In addition, for the lower Si alloy, the higher amounts of intermetallic-forming elements are thought to be contributing to the wear resistance.