Dry Shearing of Micro-Alloyed Steels

Abstract

In the production process of sheet metal parts, oil is widely used as lubricant, not only in sheet metal forming but also in shearing and blanking. Due to environment, health and cost reasons, the absence of lubricants is an aim for future production as it has initiated for machining in the last years. For lubricant-free shearing, it has to be known if there is an influence on the process itself when using oil or not. To find this out, experiments are carried out with a small testing device installed in a tensile testing machine and a blanking tool installed in a servo press. With the small device it is possible to make a piercing process with a circle punch of 16 mm diameter. The blanking tool produces a larger cut part with different holes and open cuts. Without lubricant, there is no difference in the maximum shearing force for the small device while the stripping force is higher and the cut edge zones differs slightly. Using oil or not has a small effect on the force using the blanking tool.