Abstract
This work presents new results about the dry and grease-lubricated wear resistance of borided AISI 52100 steel. Boriding was conducted at 850 °C for 1 h. The reciprocating wear tests were conducted with an alumina ball of 6 mm of diameter, with normal load of 20 N and sliding distances of 100, 150 and 200 m; a lithium grease was employed for lubrication. In comparison with heat-treated AISI 52100 steel, boriding reduced the coefficient of friction by 15–30% in dry conditions, although both stabilized similarly in grease-lubricated tests. In addition, the results showed that, for the longer sliding distance, boriding increased the wear resistance up to 8 times in dry conditions and up to 10 times using grease for lubrication. The implementation of boriding significantly improved the tribological performance of AISI 52100 steel in both tests conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.