Abstract
On-land alluvial tin mining activities produce residual materials from mineral processing or mineral washing; the major one of these is quartz sand, which can be utilized in the manufacturing industry. As time goes by, the reserves of alluvial tin are decreasing, which is in line with the increasing residual material from abundant mineral processing. Mining procedures are carried out following the Indonesian government regulations, covering mining as well as reprocessing. This motivated us to evaluate the potential of quartz sand at two mining sites in Bangka and Belitung Islands. This study evaluated alluvial tin processing residual quartz sand through drill hole spacing analysis (DHSA) by comparing two geostatistics parameters, namely global estimation variance (GEV) and kriging variance (KV). Drill hole samples were taken with varying spacing, ranging from 50 to 200 m, after which geostatistical analysis was carried out. With several simulations, the incorporation of GEV and KV was able to produce the optimal drill hole spacing with measured resource categories in the range of 40 to 55 m, indicated resources in the range of 55 to 85 m, and inferred resources >85 m. Accordingly, the total estimated quartz sand resources of both sites were obtained.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
