Abstract
This paper presents a new drill bit with a helical groove edge for drilling carbon fiber reinforced plastic (CFRP). The drill has double point angles, a helical flute, and a helical groove edge away from the drill point angle. The helical groove edge has the same rotational direction as the flute angle direction of the drill bit. With the help of the additional cutting action of the helical groove edge, the drilled holes showed eliminated burrs, reduced delamination, and decreased tearing. An analysis was conducted for the burr removal mechanism and thrust force model acting on the chip area. The experimental verification assures that the drill can produce good quality of the hole’s surface, entrance, and exit, even after long service life.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.